DIY Methods to Unclog Your Drain

We all know about the early signs. It takes a bit longer to drain the water. You’re beginning to feel the water pooling between your feet in the tub. And the sounds of it. The odd, disgusting smells. They’re all indications that you may eventually be experiencing a clogged drain. And then, boom one day. Your drainage is absolutely blocked. It’s something you’ll have to cope with immediately or incur the wrath of a blowpipe or a redundant toilet.

So, you’re scraping the extra hair and residue that’s built up on the top of the drain. But nothing is going to happen. You’re trying some fluid plumber. It’s no good. And there’s the plunger. But what occurs when it doesn’t come to the rescue? Here are some ways to deal with the clogging before you turn to the emergency plumber.

The Bent Wire Hanger

Easy enough, but pretty effective. Take your normal wire coat hanger and flatten it out as much you can. Then twist one end to make a tight knob. Move the cover over the drain and begin hunting. You’re going to be able to pull all manner of hair and gross things out of the wash. Note, you always want to get the gunk away, not drive it any further. Once you’ve got as much out of here as you can, turn the hot water, and it’s supposed to clear things up beautifully.

Baking Soda and Vinegar

In a large beaker, combine 1/3 of a cup of baking soda with 1/3 of a cup of vinegar. It’s going to fizz instantly, and you shouldn’t waste any time dumping it through the clogged drain. The fizzing motion will help to eliminate the gunk, the hair, and the dirt that has been accumulated in the pipe. If you can, let it sit for at least an hour or even overnight. Pour down a lot of hot water. Otherwise, put as much powdered baking soda into the drain first, then pour on the vinegar.

Cleaning the Pipe

There are some plumbing things I’m not going to do, but this one is simple. Second, put the empty bucket under the U-shaped tube (the trap) underneath the bowl. The bucket is going to catch the liquid that’s going to spill. Use a plumber’s wrench to remove the slip nuts on both ends of the tubing. You should be able to complete the procedure by hand.

When the trap is open, lift it and flip it upside down, clearing the remnants of the device into the bucket. You might also need to check inside for waste, and do the same with the tubes that were retaining it. An old toothbrush is fantastic for getting a rough gunk out of it. Wash the trap with the water and then bring it back together. In most situations, that’s going to do the trick.

If you feel grossed out to do it there are plenty of plumbers in Brisbane blocked drains are not really a problem anymore.

Dish Detergent

If your drain is blocked up, dump 1/4 cup of the washing powder into the bowl. Pour some boiling water, then. The washing soap serves as lube and helps to break down any oily residue. Then pour the hot water down and get ready to begin the plunging. If the plunger doesn’t cut it, the next alternative could be rubber gloves.

These are 4 fast and simple tips that can help you cope with the toughest blockages.

Leave a Reply

Your email address will not be published. Required fields are marked *